Cartographer 3D
  • Welcome
  • 🗺️Cartographer Probe
    • Scan vs Touch Modes
    • 🏗️Installation and Setup
      • Before You Begin
      • Hardware Setup
        • CAN Termination
        • Stealthburner CW2 Mount
        • Wiring Diagrams
      • Software Configuration
        • Klipper Setup
        • Klipper Configuation
        • Calibration
        • Print Start Macro
        • First Print
        • Migrating from Cartographer to Scanner
      • Creality K1 & K1 Max Specific
      • Qidi Specific Installation Instructions
    • 📐Fine Tuning
      • Cartographer Models
      • Temperature Differential Calibration
      • Useful Macros
      • Extras
    • ♻️Firmware
      • Broken Katapult Bootloader
      • CANBUS Bitrate Switching
      • Firmware Switching
        • CANBUS to USB
        • USB to CANBUS
      • Firmware Updating
        • via Katapult
          • USB Flash
          • CANBUS Flash
        • via DFU
      • Manual Methods
        • ⬆️Firmware
        • Update or Re-Flash via ST-Link
        • Switching between CAN and USB Operation (v3 only)
        • Cartographer with Input Shaper
          • Update via Katapult (recommended)
          • Update via DFU Mode
        • Archive
          • Katapult
          • Re-Flashing Firmware
          • Cartographer (rp2040)
            • DFU / U2F Bootloader Mode
          • Which Firmware?
            • Cartographer v1 (RP2040 based probe)
            • Cartographer v2 or v3 w/ Input Shaper (USB/CAN)
              • Old Firmware
          • Update via STLink
    • ⚙️Settings & Commands
    • 😭Troubleshooting
    • 🆘Need Assistance?
    • 🔗Useful Links
    • ⁉️FAQ
    • 🔧Assembly
      • Standard
      • Low Profile
      • Right Angle
    • Archive
      • v1 (RP2040 Based Probes)
        • Klipper Configuration
        • Calibration
      • Classic Installation
        • Klipper Setup
        • Klipper Configuration
        • Calibration
      • Scan Based Calibration
  • 🚠Cartographer CNC Mount
    • 🚧Installation
  • 🌪️Linear Motor
    • 🗓️Coming Soon
Powered by GitBook
On this page
  1. Cartographer Probe

Fine Tuning

Last updated 6 months ago

This section covers three different methods for calibrating or fine tuning your printer with Cartographer - SCAN MODE.

🗺️
📐
Setting models for different beds / temperatures
Temperature differential calibration
Useful macros