Cartographer 3D
  • Welcome
  • πŸ—ΊοΈCartographer Probe
    • Scan vs Touch Modes
    • πŸ—οΈInstallation and Setup
      • Before You Begin
      • Hardware Setup
        • CAN Termination
        • Stealthburner CW2 Mount
        • Wiring Diagrams
      • Software Configuration
        • Klipper Setup
        • Klipper Configuation
        • Calibration
        • Print Start Macro
        • First Print
        • Migrating from Cartographer to Scanner
      • Creality K1 & K1 Max Specific
      • Qidi Specific Installation Instructions
    • πŸ“Fine Tuning
      • Cartographer Models
      • Temperature Differential Calibration
      • Useful Macros
      • Extras
    • ♻️Firmware
      • Broken Katapult Bootloader
      • CANBUS Bitrate Switching
      • Firmware Switching
        • CANBUS to USB
        • USB to CANBUS
      • Firmware Updating
        • via Katapult
          • USB Flash
          • CANBUS Flash
        • via DFU
      • Manual Methods
        • ⬆️Firmware
        • Update or Re-Flash via ST-Link
        • Switching between CAN and USB Operation (v3 only)
        • Cartographer with Input Shaper
          • Update via Katapult (recommended)
          • Update via DFU Mode
        • Archive
          • Katapult
          • Re-Flashing Firmware
          • Cartographer (rp2040)
            • DFU / U2F Bootloader Mode
          • Which Firmware?
            • Cartographer v1 (RP2040 based probe)
            • Cartographer v2 or v3 w/ Input Shaper (USB/CAN)
              • Old Firmware
          • Update via STLink
    • βš™οΈSettings & Commands
    • 😭Troubleshooting
    • πŸ†˜Need Assistance?
    • πŸ”—Useful Links
    • ⁉️FAQ
    • πŸ”§Assembly
      • Standard
      • Low Profile
      • Right Angle
    • Archive
      • v1 (RP2040 Based Probes)
        • Klipper Configuration
        • Calibration
      • Classic Installation
        • Klipper Setup
        • Klipper Configuration
        • Calibration
      • Scan Based Calibration
  • 🚠Cartographer CNC Mount
    • 🚧Installation
  • πŸŒͺ️Linear Motor
    • πŸ—“οΈComing Soon
Powered by GitBook
On this page
  1. Cartographer Probe
  2. Installation and Setup
  3. Hardware Setup

Stealthburner CW2 Mount

PreviousCAN TerminationNextWiring Diagrams

Last updated 10 months ago

We are a huge fan of this Stealthburner CW2 mount, so thought we would make an installation guide.

πŸ—ΊοΈ
πŸ—οΈ
Step 1 - Heat Set Inserts & Endstop
Step 2 - Belts
Step 3 - Probe Installation